Windows XP Setup Could Not Detect and Find Any SATA Hard Disk Drive on AHCI Mode Windows XP安裝程序無法檢測和找到任何SATA硬碟就ahci模式

When installing Windows XP on SATA hard disk drive, you may encounter problem where you unable to install Windows XP on the SATA drive as the Windows XP setup installation interface does not detect and recognize any of the hard disks mounted on S-ATA (Serial ATA) ports, and thus XP installer cannot find usable physical disks on the computer system and unable to continue to install XP, forcing you to quit by pressing F3.當上安裝Windows XP ， SATA硬碟機，您可能會遇到的問題，您無法安裝Windows XP ，把SATA驅動器作為Windows XP安裝界面，安裝不檢測，並承認任何硬盤裝在的S - ATA （串行ATA ）連接埠，從而XP的安裝程序無法找到可用的物理磁盤上的電腦系統，並無法繼續安裝XP中，迫使你退出，由按F3 。

On newer computer and workstation system, such as Dell Precision model, if the SATA HDD is not running on RAID, there is no additional driver needed even for older operating system such as XP to recognize the drive.較新的計算機和工作站系統，如戴爾Precision模型，如果SATA硬碟上沒有運行的RAID ，是沒有額外的驅動程序需要，甚至為老年人的作業系統，如XP中認識到的驅動器。 On SATA based disk that requires a driver, normally the system OEMs or motherboard manufacturers will provide a floppy disk with needed SATA driver, which you can then use F6 button during initial setup stage to add in third-party RAID or SCSI drivers.到SATA基於磁盤，需要一名司機，通常是系統OEM廠或主板製造商將提供一個軟盤與需要的SATA驅動程序，然後，您可以使用適用於F6按鈕，在初始安裝階段，加上在第三黨的RAID或SCSI驅動程序。 On newer computer such as those from Dell, HP, Acer, Lenovo, and etc, you probably find that only diagnostics or drivers CD is provided.較新的計算機，例如那些從戴爾，惠普，宏基，聯想，等，你可能發現只有診斷或司機裁談會是提供。 The worse problem is that you simply cannot extract the SATA drivers from the CD as the driver that wanted to be installed during XP setup must be accompanied by a file named oemsetup.txt, beside the usual driver files and .INF file, else the SATA driver cannot be installed by XP setup to detect HDD.最嚴重的問題是，你根本不能提取的SATA驅動程序從CD作為驅動程序要安裝在XP安裝必須附有一份文件，名為oemsetup.txt ，旁邊的慣常的驅動程序文件和。 inf文件，否則的SATA驅動程序無法安裝XP安裝程序來檢測硬盤。

Here’sa possible solution if you’re in this kind of SATA hard drives not found situation.以下是可能的解決辦法，如果您在這種SATA硬盤沒有發現情況。 The trick is related to ACHI (Advanced Host Controller Interface) hardware mechanism which are designed to allow software to communicate with Serial ATA (SATA) devices such as host bus adapters with features not offered by Parallel ATA (PATA) controllers such as higher speeds, hot-plugging and native command queuing (NCQ).訣竅在於相關achi （高級主機控制器接口）的硬件機制，其目的是讓軟件溝通位Serial ATA （ SATA ）設備，如主機總線適配器與功能不提供並行ATA （組PATA ）控制器，如以更高的速度，熱堵塞和命令隊列（ NCQ功能） 。 Windows XP (and any OS older than Vista or linux kernel 2.6.19) does not have came pre-packaged with driver to support AHCI/SATA mode, thus creating a very common error that Windows XP中（以及任何操作系統的年紀比Vista或Linux內核2.6.19 ）沒有來預先包裝與驅動程序支持ahci /的SATA模式，從而創造一個非常常見的錯誤 Wikipedia維基百科 also described as “when attempting to install Microsoft Windows XP or a previous version on an AHCI-enabled system will cause the setup to fail with the error message ’set up could not detect hard disk drive…’”.也形容為“當試圖安裝Microsoft Windows XP或以前的版本就一ahci啟用系統將導致安裝失敗與錯誤訊息'成立無法檢測到硬盤驅動器… … ' ” 。

The ultimate solution is by using OEM Windows XP CD which comes with your system, which usually has built-in appropriate driver for S-ATA harddisks running in AHCI mode.最終的解決辦法是使用的OEM的Windows XP CD ，其中談到與您的系統，通常具有內置在適當的驅動程序的S - ATA硬盤運行在ahci模式。 However, if you lose or do not have the OEM XP CD, or is given Vista DVD but decide to downgrade to XP, there are 2 options to install XP from scratch.不過，如果你失去或不具備的OEM XP光盤，或給出了Vista DVD中，但決定降級到Windows XP ，有2個選項安裝XP是從從零開始。

Users can install Windows XP or Windows XP SP2 (Service Pack 2) on an AHCI enabled system by changing BIOS setting to disable AHCI (or RAID which includes AHCI in its functions) and use native SATA IDE emulation mode (SATA/PATA).用戶可以安裝Windows XP或Windows XP SP2 （ Service Pack 2中）就一ahci ，使系統通過改變BIOS的設置以禁用ahci （或RAID ，其中包括ahci在其職能）和使用本土的SATA的IDE仿真模式（的SATA /組PATA ） 。 In SATA IDE Emulation mode, XP setup could find the SATA drives and proceed to continue to install XP properly.在的SATA的IDE仿真模式， XP安裝程序可以找到的SATA驅動器和進行繼續安裝XP的妥善。 How to change the BIOS settings on SATA mode is depending on which brand or model or even motherboard of your computer system.如何改變BIOS設置的SATA模式是根據對其中的品牌或模型，或什至主板的您的電腦系統。 Check your system manual for more information.檢查您的系統手冊，了解更多的信息。 For example, in Dell Precision workstation, press F2 to go into BIOS, and then go to “SATA Management” to select AHCI or SATA mode.例如，在戴爾Precision工作站，按F2鍵進入BIOS的，然後去“的SATA管理”的選擇ahci或SATA模式。 If you don’t find any option in BIOS to change AHCI support for SATA ports, most probably the drives already runs in IDE (ATA) emulation mode and therefore doesn’t require the AHCI driver.如果您沒有找到任何選項，在BIOS來改變ahci支持SATA端口，最可能的驅動器已經運行在IDE中（孫占林）仿真模式，因此，並不需要ahci驅動程序。 It’s because AHCI support is depending on the chipset (commonly by Intel) and the HDD.這是因為ahci的支持是依賴於芯片組（英特爾）和硬盤。 In this case, you have to figure out what’s other在這種情況下，你必須弄清楚什麼的其他 causes that may stop your SATA disks from functioning原因，可能會停止您的SATA磁盤從運作 . 。

A slightly more difficult but recommended method is to create a slipstreamed XP install disc with the Intel Matrix Storage Manager which is also the AHCI SATA Controller driver included.稍稍增加了困難，但建議的方法是創建一個匯集XP的安裝光盤與英特爾矩陣存儲管理這亦是ahci SATA控制器驅動程序包括在內。 A slipstreamed XP setup CD with AHCI SATA controller driver allows the XP OS to support hard disk on AHCI and use its advanced features such as NCQ for faster access, read and write speed.匯集XP安裝CD與ahci SATA控制器驅動程序，讓XP的操作系統支持的硬盤ahci和利用其先進的功能，如NCQ功能，為更快地訪問，閱讀和書寫速度。 While slipstreaming, users can also have the advantage to include all updates for Windows XP for up-to-date patched OS, without the need to download and install hotfixes later.而匯集，用戶還可以有其優點，包括所有更新適用於Windows XP的不斷更新的補丁的操作系統，而不需要下載並安裝修補程序後。

IMPORTANT : This is a machine translated page which is provided "as is" without warranty. 重要說明 ：這是一個機器翻譯網頁是“按原樣”提供的擔保。 Machine translation may be difficult to understand.機器翻譯可能很難理解。 Please refer to請參閱 original English article英文原版的文章 whenever possible.只要有可能。

Share and contribute or get technical support and help at分享和貢獻，或取得技術的支持和幫助，在 My Digital Life Forums 我的數字生活論壇 . 。

Related Articles相關文章

• Common Troubleshooting Methods When OS Install Unable to Detect SATA Harddisk Drive常見故障排除方法時， OS的安裝無法檢測到的SATA硬盤驅動器
• Stop 0×0000007B Inaccessable_Boot_Device Error After Enable AHCI Mode on SATA Drive in Vista停止0 × 0000007b inaccessable_boot_device錯誤後，使ahci模式對SATA硬盤在Vista
• SATA CD/DVD-ROM Optical Drive Disappears After Enabling AHCI Mode in Vista的SATA的CD / DVD光碟光盤驅動器後消失，使ahci模式在Vista
• Improve SATA (Serial-ATA) Hard Disk Drive Speed Performance in Vista改善的SATA （串行ATA ）硬盤驅動器的高速性能在Vista
• NewerTech Universal Drive Adapter for External PATA and SATA Hard Disk Drive newertech普遍驅動器適配器外部的PATA和SATA硬盤驅動器
• Apricorn DriveWire Provides Easy Hard Drive Cloning and System Upgrading Apricorn更多drivewire提供簡便的硬盤驅動器的克隆和系統升級
• How to Downgrade Windows Vista to XP如何降級的Windows Vista到Windows XP
• Change or Modify the Drive Letter and Paths in Windows Vista更改或修改的驅動器號和路徑，在Windows Vista
• Buffalo Portable Hard Drive With Turbo Mode水牛的便攜式硬盤驅動器與渦輪增壓方式
• Toshiba Satellite A135-S4499 Laptop東芝衛星a135 - s4499筆記本電腦

This entry was posted on Tuesday, October 23rd, 2007 at 2:25 am and is filed under 此項目被張貼於週二， 2007年10月23日在上午02時25分，並提交下 Operating Systems 操作系統 . 。 You can follow any responses to this entry through the 您可以按照任何的反應，此項目通過 RSS 2.0 2.0 feed. 餵養。 You can 您可以 leave a response 留下的回應 , or ，或 trackback Trackback跟踪 from your own site. 從你自己的網站。