Comments on: Common Troubleshooting Methods When OS Install Unable to Detect SATA Harddisk Drive

By: goony

goony — Sat, 13 Dec 2008 14:29:19 +0000

nice to read that you can fix this blunder from microsoft. One little note….you need to have the driver on a floppy….humz…most new computers who use a sata controller don’t have floppydrives….

By: Mintys » Blog Archive » Windows XP and SATA drives

Mintys » Blog Archive » Windows XP and SATA drives — Thu, 13 Dec 2007 15:42:17 +0000

[...] Users can install Windows XP or Windows XP SP2 (Service Pack 2) on an AHCI enabled system by changing BIOS setting to disable AHCI (or RAID which includes AHCI in its functions) and use native SATA IDE emulation mode (SATA/PATA). In SATA IDE Emulation mode, XP setup could find theSATA drives and proceed to continue to install XP properly. How to change the BIOS settings on SATA mode is depending on which brand or model or even motherboard of your computer system. Check your system manual for more information. For example, in Dell Precision workstation, press F2 to go into BIOS, and then go to “SATA Management” to select AHCI or SATA mode. If you don’t find any option in BIOS to change AHCI support for SATA ports, most probably the drives already runs in IDE (ATA) emulation mode and therefore doesn’t require the AHCI driver. It’s because AHCI support is depending on the chipset (commonly by Intel) and the HDD. In this case, you have to figure out what’s other causes that may stop your SATA disks from functioning. [...]

By: Windows XP Setup Could Not Detect and Find Any SATA Hard Disk Drive on AHCI Mode » My Digital Life

Tue, 23 Oct 2007 04:54:13 +0000

[...] Users can install Windows XP or Windows XP SP2 (Service Pack 2) on an AHCI enabled system by changing BIOS setting to disable AHCI (or RAID which includes AHCI in its functions) and use native SATA IDE emulation mode (SATA/PATA). In SATA IDE Emulation mode, XP setup could find the SATA drives and proceed to continue to install XP properly. How to change the BIOS settings on SATA mode is depending on which brand or model or even motherboard of your computer system. Check your system manual for more information. For example, in Dell Precision workstation, press F2 to go into BIOS, and then go to “SATA Management” to select AHCI or SATA mode. If you don’t find any option in BIOS to change AHCI support for SATA ports, most probably the drives already runs in IDE (ATA) emulation mode and therefore doesn’t require the AHCI driver. It’s because AHCI support is depending on the chipset (commonly by Intel) and the HDD. In this case, you have to figure out what’s other causes that may stop your SATA disks from functioning. [...]