Disable and Turn Off IPv6 Support in Vista IPv6のサポートを無効にしたり、無効にするビスタ
IPv6 (Internet Protocol version 6) is the successor for IPv4, the current version of most popular network layer protocol for packet-switched internetworks used on the Internet.のIPv6 (インターネットプロトコルバージョン6 )は、 IPv4の後継者を、現在のバージョンの最も人気のパケット交換ネットワーク層のプロトコルを、インターネット上のinternetworks使われています。 In Windows Vista, IPv6 is fully implemented and supported, is also installed and enabled by default, with full Internet Protocol security (IPsec) support for IPv6 traffic and Teredo tunneling support for non-IPv6 aware devices. Windows Vistaでは、 IPv6が完全に実装およびサポートをインストールし、有効になってもデフォルトでは、インターネットプロトコルを完全にセキュリティ( IPSec )のサポートをIPv6トラフィックとTeredoトンネリングIPv6の認識以外のデバイスのサポートをします。
IPv6 is not common yet, as most software, routers, modems, and other network equipments does not support the emerging and future-proof protocol yet. IPv6のではない共通のしかし、ほとんどのソフトウェアとして、ルータ、モデム、およびその他のネットワーク機器をサポートしていません新興と未来-証明プロトコルはまだありません。 Beside, turning off IPv6 support does not affect the functionality of Internet browsing for average users.横に、 IPv6サポートを無効にするには影響しませんインターネットブラウジングの機能をユーザーの平均です。 Thus IPv6 and/or Teredo can and (quite likely) should be disabled if it’s not in use to conserve system resources.そのためのIPv6および/またはTeredoのできることと(おそらく)が使用されていない場合は無効になってシステムリソースを節約します。 Unlike Windows XP, IPv6 in Windows Vista cannot be uninstalled, according toとは異なり、 Windows XPでは、 Windows VistaでのIPv6をアンインストールすることはできませんによると、 Microsoftマイクロソフト .です。 However, IPv6 can be disabled.しかし、 IPv6のことが無効になっています。 The following guide will allow users to disable IPv6 on a specific connection of a network interface card.により、ユーザは、次のガイドでは、特定の接続を無効にするにIPv6をネットワークインターフェイスカードです。
- Go to Network Connections folder (click on Start button, then right click on Network, select Properties, then click on “Manager network connections” on Tasks pane).ネットワーク接続]フォルダに行く(スタート]ボタンをクリックしてボタンを押すと、ネットワークを右クリックして入力し、 [プロパティ]をクリックをクリックして"ネットワーク接続マネージャ"をタスクペイン) 。
- You should see various LAN, wireless, Bluetooth, high speed Internet, and other network connections available on the Vista computer with the network adapter description.表示されるはず様々な無線LAN 、ワイヤレス、ブルートゥース、高速インターネット、およびその他のネットワーク接続を検索するVistaのコンピュータで利用可能なネットワークアダプタの説明書です。 Right click on the network connection that you want to disable the IPv6 interface and select “Properties”.を右クリックして、ネットワークに接続してIPv6のインターフェイスを無効にするにしたいと選択して"プロパティ"です。
Click “Continue” on User Access Control permission request prompt.をクリックし、 "続行"をしているユーザーのアクセスコントロールのアクセス許可の要求プロンプトを起動します。
- Clear the check box next to the Internet Protocol version 6 (TCP/IPv6) component in the list under “This connection uses the following items” box.クリアしての横にあるチェックボックスをオンには、 インターネットプロトコルバージョン6 ( tcp/ipv6 )コンポーネントは、リストの下に"この接続を使用して次の項目の"ボックスをオンします。
- Click OK when done.終了したら、 [ OK ]をクリックします。
- To re-enable IPv6, tick back the check box.を再度有効にIPv6では、ダニ先頭のチェックボックスをオンにします。
This method disables IPv6 on the particular LAN interface and connection.このメソッドにIPv6を無効にする特定の無線LANインターフェイスと接続します。 For other network adapter or connection, users have to repeat the steps to disable IPv6.他のネットワークアダプタまたは接続を繰り返して、ユーザーが無効にする手順を実行してIPv6のです。 Beside, disable IPv6 also does not disable IPv6 on tunnel interfaces or the IPv6 loopback interface.横に、無効にIPv6のトンネルにIPv6を無効にもされない、 IPv6のインターフェイスまたはループバックインターフェイスです。
It’s also possible to disable IPv6 and/or Teredo via Vista system registry.のIPv6を無効にすることもできますおよび/または経由でVistaのシステムレジストリTeredoのです。 The registry settings also allow users to selectively disable components and configure behaviors for IPv6 in Windows Vista.は、レジストリの設定もユーザに許可するコンポーネントを選択し、設定を無効にIPv6のWindows Vistaで動作します。
- Open Registry Editor (regedit).オープンレジストリエディタ( Regedit )です。
- Navigate to the following registry key branch:支店に移動して、次のレジストリキー:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\。 HKEY_LOCAL_MACHINE\システム\ currentcontrolset \
Services\tcpip6\Parameters\サービス\ tcpip6 \パラメータ\ - Create the following registry value (DWORD type):作成して、次のレジストリ値( DWORD値のタイプ) :
DisabledComponents disabledcomponents
Note that the name must be exactly as shown, including capitalization.に注意してしなければならないの名前を正確に示すように、大文字と小文字を含む。 DisabledComponents is set to 0 by default. disabledcomponentsデフォルトでは0に設定されています。
- The DisabledComponents registry value is a bit mask that controls the following series of flags, starting with the low order bit (Bit 0). disabledcomponentsレジストリ値は、ビットマスクを制御するフラグは、次のシリーズをはじめとする低注文ビット(ビット0 ) 。 To determine the value of DisabledComponents for a specific set of bits, the process is complicated, were hexadecimal value is calculated from binary number of the bits in correct position. disabledcomponentsの値を確認するには、特定の設定のビットは、このプロセスは複雑で、バイナリから計算された値は16進数のビット数を正しい位置にします。 For convenient, the following table lists some common configuration combinations and the corresponding DWORD value of DisabledComponents.便利に、次の表の組み合わせとそれに対応するいくつかの共通の構成disabledcomponents DWORD値です。
Configuration combination構成の組み合わせ DisabledComponents value disabledcomponents値 Disable all tunnel interfacesトンネルインターフェイスをすべて無効にする 0×1 0 × 1 Disable 6to4 6to4の無効 0×2 0 × 2 Disable ISATAP無効にisatap 0×4 0 × 4 Disable Teredo無効にTeredo 0×8 0 × 8 Disable Teredo and 6to4 Teredoの無効と6to4の 0xA 0xAが発生 Disable all LAN and PPP interfaces無線LANや、 pppのインターフェイスをすべて無効に 0×10 0 × 10 Disable all LAN, PPP, and tunnel interfacesすべて無効にする無線LANと、 PPP 、およびトンネルインターフェイス 0×11 0 × 11 Prefer IPv4 over IPv6 IPv4のを好むのIPv6 0×20 0 × 20 Disable IPv6 over all interfaces and prefer IPv4 to IPv6 IPv6のすべてのインターフェイスを無効にするとIPv4からIPv6を好む 0xFF 0xFFまで As seen from table above, to disable IPv6 support globally on all interface, set the value data for DisabledComponents to 000000FF , or simply FF .テーブルの上から見たとして、世界的にIPv6サポートを無効にするすべてのインターフェイスは、値のデータを設定してdisabledcomponentsを000000ffか、または、単にFFを指定します。 The registry entry will look like below:以下は、レジストリのエントリは次のように:
[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip6\Parameters][ 。 HKEY_LOCAL_MACHINE \システム\ currentcontrolset \サービス\ tcpip6 \パラメータ]
“DisabledComponents”=dword:000000ff" disabledcomponents " = DWORD値:000000ff - Restart the computer for changes to take effect.コンピュータを再起動して変更を有効にします。
- To revert and enable IPv6, delete “DisabledComponents” registry key or set its registry value to 0.を元に戻すにし、有効にIPv6では、削除" disabledcomponents "レジストリキーを押すか、レジストリの値を0に設定します。
More ways available to他の方法で利用できるように disable Toredo for IPv4 and IPv6 bridge IPv4とIPv6ブリッジを無効にtoredo .です。
IMPORTANT : This is a machine translated page which is provided "as is" without warranty. 重要 :これは、機械翻訳ページで提供"現状有姿"を保証します。 Machine translation may be difficult to understand.機械翻訳を理解するのは難しいかもしれません。 Please refer toを参照してください original English articleオリジナルの英語記事索引 whenever possible.いつ可能です。
Share and contribute or get technical support and help atを共有して貢献や技術サポートとヘルプを得る My Digital Life Forums 私のデジタルライフフォーラム .です。
Related Articles関連記事
- How to Disable TCP/IPv6 Teredo Tunneling in Vista Teredoのトンネリングを無効にする方法をtcp/ipv6ビスタ
- How to Enable and Turn On Hibernation Feature in Windows Vista休止状態を有効にする方法や機能をWindows Vistaの電源をオンに
- Temporarily Disable IE7 Protected Mode in Vista on Ad-hoc Basis一時的に無効にie7プロテクトモードでVistaをアドホック的に
- Ways to Turn Off and Disable Vista IE 7 Protected Modeビスタを無効にする方法を無効にするとie 7をプロテクトモード
- How to Disable or Enable Vista User Access Control in Command Promptビスタを無効にする方法ユーザーのアクセス制御を有効またはコマンドプロンプト
- Disable Compressed (Zipped) Folder Feature in Windows XP and Windows Me無効に圧縮( zip形式)フォルダ機能では、 Windows XPおよびWindows Me
- Disable and Turn Off ClearType Fonts in Windows Vista無効にしたり、 Windows VistaのClearTypeフォントを無効にする
- How to Disable and Turn Off Compressed Folder and ZIP Support in Vista (Including Cabinet File)を無効にする方法やzip圧縮フォルダを無効にするとサポートされビスタ(キャビネットファイルを含む)
- Emulate Expanded (EMS) Memory Support in Vista with EMS Magicエミュレートする拡張( EMS )のメモリをサポートされVistaでのEMSのマジック
- Disable and Turn Off Highlight Newly Installed Programs Feature無効にしたり、新たにインストールされたプログラムのハイライト機能を無効にする















September 9th, 2007 23:50 2007年9月9日23:50
[...] is installed and enabled by default in Windows Vista, and users cannot uninstall them. [...]がインストールされ、デフォルトで有効になっWindows Vistaでは、それらとユーザをアンインストールすることはできません。 Users can turn off IPv6 support in Vista. IPv6のサポートを無効にするユーザーはVistaのです。 Teredo client in Windows Vista is enabled but inactive by default, but it will activate [...] Windows VistaでTeredoクライアントが有効になってしかし、非アクティブなデフォルトでは、しかし、それが実行さ[...]